Configuration Mode (ConF)
Code Nam e / De s cription Adjustment range Factory setting
tnL
nO
YES
[Autotune fault mgt]
[Freew heel]
(YES)
[Ignore]
(nO): Detected fault ignored
[Freew heel]
(YES): Freew heel stop
(1) Because, in this case, the detected fault does not trigger a stop, it is recommended to assign a relay or logic output to
its indication.
These parameters only appear if the corresponding function has been selected in another menu. When the parameters can
also be accessed and adjusted from w ithin the configuration menu for the corresponding function, their description is detailed
in these menus, on the pages indicated, to aid programming.
Parameter that can be modified during operation or w hen stopped.
Parameters described in this page can be accessed by:
DRI- > CONF > FULL > FLT- > TNF-
*
To Next Page
