Index of Parameter Codes
Glossary
D
Display terminal
The dis play term inal m enus are s hown in s quare brackets.
For exam ple:
[Communication]
The codes are shown in round brackets.
For exam ple: CO M-
Param eter nam es are displayed on the display term inal in s quare brackets.
For exam ple:
[Fallback Speed]
Param eter codes are dis played in round brackets.
For exam ple:
LFF
E
Error
Dis crepancy between a detected (com puted, m easured, or signaled) value or condition and the
specified or theoretically correct value or condition.
F
Factory setting
Factory s ettings when the product is s hipped
Fault
Fault is an operating s tate. If the m onitoring functions detect an error, a trans ition to this operating
state is triggered, depending on the error clas s . A "Fault res et" is required to exit this operating
state after the caus e of the detected error has been rem oved. Further inform ation can be found in
the pertinent s tandards s uch as IEC 61800-7, ODVA Com mon Indus trial Protocol (CIP).
Fault Reset
A function used to res tore the drive to an operational state after a detected error is cleared by
rem oving the cause of the error s o that the error is no longer active.
M
Monitoring function
Monitoring functions acquire a value continuous ly or cyclically (for exam ple, by m easuring) in order
to check whether it is within perm issible limits. Monitoring functions are us ed for error detection.
Glossary
P
Parameter
Device data and values that can be read and s et (to a certain extent) by the us er.
341
14
To Next Page
Loading...
