Configuration Mode (ConF)
Macro Configuration
Code Nam e / De s cription Factory setting
CFG
[Macro configuration]
[Start/Stop]
(StS)
*
WARNING
UNANTICIPATED EQUIPMENT OPERATION
Verify that the selected m acro configuration is com patible with the type of wiring used.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
[Start/Stop]
(StS): Start/stop
[M . handling]
(HdG): Handling
[Hoisting]
(HSt): Hoisting
[Gen. Us e ]
(GEn): General use
[PID re gul.]
(PId):
PID regulation
[Netw ork C.]
(nEt): Communication bus
2 s
StS
These parameters only appear if the corresponding function has been selected in another menu. When the parameters can
also be accessed and adjusted from w ithin the configuration menu for the corresponding function, their description is detailed
in these menus, on the pages indicated, to aid programming.
To change the assignment of this parameter, press the ENT key for 2 s.
Example of total return to factory settings
•
[
C
onfig. So
urce]
(
FCS
I
) is s et to
[Macro-Conf]
(
In
I
)
•
[PARAMETER GROUP LIST]
(FrY-)
is set to
[All]
(ALL)
•
[Goto FACTORY SETTINGS]
(GFS) is set to
[Yes]
(YES)
Parameters described in this page can be accessed by:
DRI- > CONF
2 s
*
To Next Page
Loading...
