Application functions
The tables on the following pages s how the com binations of functions and applications, in order to guide your
selection.
The applications in thes e tables relate to the following m achines, in particular:
•
Hoisting
: cranes , overhead cranes , gantries (vertical hois ting, trans lation, s lewing), lifting platforms
•
Handling
: palletizers /depalletizers , conveyors , roller tables
•
Packing
: carton packers , labeling m achines
•
Textiles
: weaving loom s , carding fram es, was hing m achines, s pinners, drawing frames
•
Wood
: autom atic lathes , s aws, m illing
•
Process
Each m achine has its own special features, and the com binations listed here are neither m andatory nor
exhaus tive.
Som e functions are des igned s pecifically for a particular application. In this cas e, the application is identified
by a tab in the m argin on the relevant program ming pages.
Motor control functions
Functions Page Applications
Hoist ing
Handlin g
Packin g
Textile s
Wood
Proce s s
V/f ratio 105
Sensorless flux vector control 105
2-point vector control 105
Open-loop synchronous motor 105
Output frequency up to 599 Hz 105
Motor overvoltage limiting 120
DC bus connection (see Installation manual)
-
Motor fluxing using a logic input 189
Sw itching frequency of up to 16 kHz 94
Auto-tuning 87
To Next Page
Loading...
