Configuration Mode (ConF)
Code Nam e / De s cription Adjustment range Factory setting
Behavior of the drive in the event of a communication interruption w ith a communication card.
nO
[Ignore]
(nO): Detected fault ignored
fault relay does not open and the drive is ready to restart as soon as the detected fault disappears, according to the restar
if control is via the terminals). Configuring an alarm for this detected fault is recommended (assigned to a logic output, for
example) in order to indicate the cause of the
The drive maintains the speed being applied w hen the detected fault
occurred, as long as the detected
fault is present and the run command has not been removed (1)
DC injection stop. This type of stop cannot be used w ith certain other functions. See table on page
COL
[CANopen fault mgt]
[Freew heel]
(YES)
nO
WARNING
LOSS OF CONTROL
If this param eter is set to
[Ignore]
(nO), CANopen com m unication m onitoring is disabled.
•
Only us e this s etting after a thorough ris k as sessment in com pliance with all regulations and s tandards
that apply to the device and to the application.
•
Only us e this s etting for tes ts during commissioning.
•
Verify that com m unication m onitoring has been re-enabled before com pleting the com missioning
procedure and perform ing the final com missioning tes t.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
Behavior of the drive in the event of a communication interruption w ith integrated CANopen®.
[Ignore]
(nO): Detected fault ignored
[Freew heel]
(YES): Freew heel stop
[Per
STT]
(
Stt
):
Stop
according
to
configuration
of
[Type
of
stop]
(
St
t
)
page
173,
without
fault
tripping.
In
this
case,
the
fault relay does not open and the drive is ready to restart as soon as the detected fault disappears, according to the restart
condition s
of
the
active
command
channel
(for
example,
according
to
[2/3
wire
control]
(
tCC
)
and
[2
wire
type]
(
tCt
)
page
125
if control is via the terminals). Configuring an alarm for this detected fault is recommended (assigned to a logic output, for
example) in order to indicate the cause of the stop.
[fallback spd]
(LFF): Change to fallback speed, maintained as long as the detected fault persists and the run command has
not been removed (1)
[Spd m aint.]
(rLS):
The drive maintains the speed being applied w hen the detected fault occurred, as long as the detected
fault is present and the run command has not been removed (1)
[Ram p s top]
(rMP): Stop on ramp
[Fast s top]
(FSt): Fast stop
[DC injection]
(dCI):
DC injection stop. This type of stop cannot be used w ith certain other functions. See table on page 165.
LFF
rLS
rMP
SLL
[Modbus fault mgt]
[Freew heel]
(YES)
WARNING
LOSS OF CONTROL
If this param eter is set to
[Ignore]
(nO), Modbus com munication m onitoring is disabled.
•
Only us e this s etting after a thorough ris k as sessment in com pliance with all regulations and s tandards
that apply to the device and to the application.
•
Only us e this s etting for tes ts during commissioning.
•
Verify that com m unication m onitoring has been re-enabled before com pleting the com missioning
procedure and perform ing the final com missioning tes t.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
Parameters described in this page can be accessed by:
DRI- > CONF > FULL > FLT- > CLL-
To Next Page
Loading...
