Configuration Mode (ConF)
Code Nam e / De s cription Adjustment range Factory setting
tdC
*
(1) (3)
[DC injection time 2]
0.1 to 30 s 0.5 s
NOTICE
OVERHEATING AND DAMAGE TO THE MOTOR
Verify that the connected m otor is properly rated for the DC injection current to be applied in term s of am ount
and tim e in order to avoid overheating and dam age to the m otor.
Failure to follow these instructions can result in equipment damage.
Maximum injection time
[DC inject. le vel 2]
(IdC2)
for injection, selected as stop mode only.
This
paramet er
can
be
accessed
if
[Type
of
stop]
(
St
t
)
is
set
to
[DC
injec t ion ]
(
dCI
).
(1)
The parameter can also be accessed in the
[SETTINGS]
(SEt-)
and
[APPLICATION FUNCT.]
(FUn-)
menus.
(2)
In corresponds to the rated drive current indicated in the Installation manual and on the drive nameplate.
(3)
These settings are independent of the
[AUTO DC INJECTION]
(AdC-) function.
These parameters only appear if the corresponding function has been selected in another menu. When the parameters can
also be accessed and adjusted from w ithin the configuration menu for the corresponding function, their description is detailed
in these menus, on the pages indicated, to aid programming.
Parameter that can be modified during operation or w hen stopped.
*
To Next Page
Loading...
