Drive systems may perform unexpected movements because of incorrect wiring, incorrect settings, incorrect
data or other errors.
Damaged products or accessories may cause electric shock or unanticipated equipment operation.
Contact your local BLEMO sales office if you detect any damage.
1 .
For USA: Additional inf ormation, ref er to NEMA ICS 1.1 (latest edition), “Saf ety Guidelines f or the Application, Installation, and
Maintenance of Solid State Control” and to NEMA ICS 7.1 (latest edition), “Saf ety Standards f or Construction and Guide f or Selection,
Installation and Operation of Adjustable-Speed Driv e Sy stems”.
WARNING
UNEXPECTED EQUIPMENT OPERATION
Carefully install the wiring in accordance with the EMC requirements.
Do not operate the product with unknown or unsuitable settings or data.
Perform a comprehensive commissioning test.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
ELECTRIC SHOCK OR UNANTICIPATED EQUIPMENT OPERATION
Do not use damaged products or accesssories.
Failure to follow these instructions will result in death or serious injury.
WARNING
LOSS OF CONTROL
• The designer of any control scheme must consider the potential failure modes of control paths and, for
critical control functions, provide a means to achieve a safe state during and after a path failure. Examples
of critical control functions are emergency stop, overtravel stop, power outage and restart.
• Separate or redundant control paths must be provided for critical control functions.
• System control paths may include communication links. Consideration must be given to the implications
of unanticipated transmission delays or failures of the link.
• Observe all accident prevention regulations and local safety guidelines.
1
• Each implementation of the product must be individually and thoroughly tested for proper operation before
being placed into service.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
NOTICE
DESTRUCTION DUE TO INCORRECT MAINS VOLTAGE
Before switching on and configuring the product, verify that it is approved for the mains voltage.
Failure to follow these instructions can result in equipment damage.
To Next Page
Loading...
