4. Loosen the eight hexagon head screws (1) with washers on
the motor plate (4) and remove the unit consisting of the drive
(5), the O-ring (3) and the motor plate (4) from the pipe
casing (2) using a suitable hoist.
NOTE!
Hold the unit in such a way that lubricant does not run out of
the gear unit breather.
WARNING!
Risk of fatal injury due to suspended loads!
Loads can swing and fall during lifting operations. This can
cause severe injury, including death.
— Never stand under or within the swinging range of sus-
pended loads.
— Do not move loads unsupervised.
— Only use approved hoists and slings with sufficient load-
bearing capacity.
— Do not use torn or worn hoists such as ropes and belts.
— Do not place hoists such as ropes and belts near sharp
corners and edges and do not tie them together or twist
them.
— Put the load down when leaving the operating site.
Maintenance and repairs
BA-RC40_EN, 17.01.2024 www.boerger.de / www.boerger.com 141
To Next Page
Loading...