DANGER!
Risk of injury due to rotating parts!
Moving parts can cause severe injury.
— Do not reach into rotating parts or handle rotating parts when
the machine is in operation.
— Never open protective covers when in operation.
— Perform work on the Börger machine only when stationary.
— Observe the delay time: Prior to opening protective covers,
make sure that all components have stopped moving.
— Shut down the machine and upstream and downstream
system components before carrying out any work on the
Börger machine or accessories.
Ä
Chapter 5.4 “Downtimes”
on page 100
— The operating person is obligated to check that all safety
equipment is installed and fully functional before putting the
machine into operation.
— The Börger machine must only be switched on when the inlet
and outlet connections have been established and the mainte-
nance openings have been securely installed.
WARNING!
Risk of fatal injury due to suspended loads!
Loads can swing and fall during lifting operations. This can cause
severe injury, including death.
— Never stand under or within the swinging range of suspended
loads.
— Do not move loads unsupervised.
— Only use approved hoists and slings with sufficient load-
bearing capacity.
— Do not use torn or worn hoists such as ropes and belts.
— Do not place hoists such as ropes and belts near sharp cor-
ners and edges and do not tie them together or twist them.
— Put the load down when leaving the operating site.
Safety
BA-RC40_EN, 17.01.2024 www.boerger.de / www.boerger.com 19
To Next Page
Loading...