Brooks PreciseFlex 400 - Installation Information; Environmental and Facilities Requirements

4. Installation Information (Undefined variable: MyVariables.ProductName)
Environmental Specifications Part Number: PF40-DI-00010 Rev. A
4. Installation Information
Environmental Specifications
The PreciseFlex
TM
robots must be installed in a clean, non-condensing environment. Light fluid
splashing around the base of the robot is acceptable, but this robot is not intended for use in a
washdown or spray environment. See the Environmental Specifications in Appendix B:
Environmental Specifications for specific environmental limits.
Facilities Connections
The Facilities Panel (Figure 4-1 and Table 4-1) at the base of the robot (and optional linear axis end
cap) includes:
l
System AC input power receptacle
l
Lighted AC on/off power switch
l
Connectors for controller input and output signals
37
Copyright © 2023, Brooks Automation