Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 12- 5
Electric drive motor – 1760
Bearing replacement
12.4.3 Assembling
Ensure all parts are intact and clean before re-assembly.
N-side
• Press the bearing (5) on the rotor axle.
• Replace the bearing cap (8) on the motor axle.
• Install the flange ring (17).
• Refit the washer (18) and circlip (16).
• Screw the bearing cap (8) and shield (3) together using the screws
(34) to a torque of 6 Nm.
• Fit the insulation hose on the sensor bearing cable.
• Place the terminal block (10) between the shields.
• Tighten the stud bolts (20) to a torque of 5 Nm.
• Tie the cables for the thermocontact and the sensor bearing to the
middle power cable.
D-side
• Install a gasket (30) on the bearing housing (29).
• Press the bearing (28) into the bearing housing.
• Fit the circlip (26).
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...