Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 19- 1
Mechanical steering system – 4100
General
19- Mechanical steering system – 4100
19.1 General
The steering generatoris fitted in the steering panel and has direct
contact with the steering wheel. When you turn the steering wheel the
steering generator sends voltage to the steering motor via the electron
-
ic card.
19.2 Replacing the steering generator
19.2.1 Dismantling
• Loosen the bolts on the lower panel and remove it.
• Disconnect the connector on the steering generator.
• Dismantle the steering wheel by unscrewing the bolts around the
steering generator.
• Loosen the bolts in the driving disc and remove it from the steering
generator.
• Unscrew the bolts holding the steering generator on the steel bracket.
19.2.2 Assembling
• Bolt the steering generator onto the steel bracket.
• Secure the driving disc on the steering generator’s shaft.
• Replace the O-ring on the driving disc if necessary.
• Bolt the steering wheel onto the steel bracket.
• Connect the steering generator’s electrical connector.
• Bolt on the lower panel.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...