Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 20- 1
Steering angle sensor – 4350
General
20- Steering angle sensor – 4350
20.1 General
These instructions apply to adjustment of the steering angle sensor
mounted on the driving gear.
20.2 Procedure
The information supplied by the two directional arrows in the display
changes as the sensor detects a change between the high and low lev
-
el in the driving gear.
The two-way sensor uses the gear wheel to calculate the steering
angle and displays the value in the display's compass rose.
NOTE:
The sensor may be damaged if it is adjusted against an incorrect sur-
face.
Always adjust the sensor against the upper surface.
20.1 Adjustment of directional sensor
Adjust the sensor to a detection range of 1 mm.
• Screw the sensor onto the machined surface until the two touch
each other.
• Then unscrew one full rotation.
• Verify that the LED on the sensor/electronic card lights when it is in
front of the machined surface.
1 mm
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...