T-code Valid from serial number
403-414, 669-671, 716-718 713962-
Date Order number
2005-06-01 218920-040
33- 6 Service Manual REFLEX RR B/E, RR B/E CC © BT Europe AB
Tilt cylinder – 6660.1
Mast without valve on the fork carriage
33.3.2 Dismantling the cylinder
• Unscrew the eight bolts (7).
• Carefully pull the rod out of the cylinder so that the threads are not
damaged. Place the rod on a soft and clean surface so that it is not
damaged.
33.3.3 Dismantling the rod seal
• Knock a screwdriver in the rod seal without making any marks what-
soever on the ram.
NOTE!
If a ram is scratched it must be replaced to
prevent leakage from occurring.
• Very carefully lift up the rod seal.
• Carefully cut off the rod seal using a knife so that not damage is
caused to the ram.
33.3.4 Dismantling the ram
• Remove the rod seal.
• Knock and heat the ram a little, if necessary.
• Unscrew the ram using pipe wrench 08-15393.
• Brush off any old flange sealant.
33.3.5 Assembling the ram
• Apply OMNI 230 on the thread.
• Screw in the ram using a hook spanner.
• Take care to wipe off all surplus sealant.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...