BT REFLEX RR B2-3CC - 33.2 Mast with valve on the fork carriage; 33.2.1 Dismantling the fork carriage

T-code Valid from serial number
403-414, 669-671, 716-718 713962-
Date Order number
2005-06-01 218920-040
33- 2 Service Manual REFLEX RR B/E, RR B/E CC © BT Europe AB
Tilt cylinder – 6660.1
Mast with valve on the fork carriage
33.2 Mast with valve on the fork carriage
33.2.1 Dismantling the fork carriage
• Lift up the fork carriage to the right working height.
• Remove the forks.
• Remove the clamping ring to dismantle the side shift (2) or the stay
(1).
• Loosen the bolts (11) and remove the stop lug (12).
• Secure a lifting strap around the fork yoke (3) and lift out using an
overhead crane.
• Unscrew the bolts (4) and remove the plate (5) and the sliding block
(6).
• Loosen the nut/bolt (15) and unbolt the bolts (10) from the fork car-
riage (13).
• Remove the tilt cylinder.
• Knock out the spiral pin (8) and remove the plate (7).
1
2
3
4
5
6
78
9
10
11
12
1
3
14
15
https://www.forkliftpdfmanuals.com/