BT REFLEX RR B2-3CC - 24.4 Displaying and programming; 24.4.1 Keypad

T-code Valid from serial number
403-414, 669-671, 716-718 713962-
Date Order number
2005-06-01 218920-040
24- 8 Service Manual REFLEX RR B/E, RR B/E CC © BT Europe AB
Electronic card – 5710
Displaying and programming
24.4 Displaying and programming
It is possible to look up items in the machine-specific register, but not to
reprogram it. It is possible, however, to program driver-specific param
-
eters and set the clock. The parameters are indicated in the table.
If the driver has not logged out with the 0 key, the truck will automatical-
ly perform the log-out operation after a specified time.
.
24.4.1 Keypad
Do as follows to check the driver and machine-specific register set-
tings:
• Enter the driver PIN-code and then depress the green I key on the
keypad so that the electronic card will recieve positive feed, at the
same time push the travel direction selector in the fork direction.
The following functions will scroll across the display:
• Time of day CL
• Parameters P
• Serial number of software Pn
• Operating hours H
• Error codes E
Release the travel direction selector at the desired item.
Use the lift/lowering lever to increase/decrease the value.
The travel direction selector is used for the different adjustment modes.
The display shows the following functions:
- (C) Time of day
- (D) parameters, serial number of software, operating hours and
error codes
The "No." of the address register is displayed on the left side, while the
"value" is displayed on the right side.
AB D
J
K
C
E
F
G
HI
https://www.forkliftpdfmanuals.com/