BT REFLEX RR B2-3CC - 30- Main lift cylinder - 6610; 30.1 General; 30.2 Tools

Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 30- 1
Main lift cylinder – 6610
General
30- Main lift cylinder – 6610
30.1 General
This instruction describes the main lift cylinders in the Newton mast.
There are two lifting cylinders on each mast. A hose rupture valve is
located on each cylinder that prevents the forks from falling in the event
of a hose rupturing.
We recommend that all masts, irrespective of the lifting height, are
raised before the cylinders are dismantled. Applies to 1600 and 2000
kg masts.
30.2 Tools
For lift cylinders on the mast and valve in the fork yoke.
(1600 and 2000 kg masts).
Tool
number
Comments
08-15364 To protect the rod seals from damage against the
cylinder threads.
08-15366 Assembling the rod seal on 08-15367
08-15367 Assembling the rod seal on the ram
08-15368 Assembling the stop ring on 08-15369
08-15369 Assembling the stop ring on 08-15370
08-15370 Assembling the stop ring on the rod
08-15391 Hook spanner 60-90 with 5 mm pin
08-15393 Pipe wrench
08-15400 Assembling the hose rupture valve
https://www.forkliftpdfmanuals.com/