BT REFLEX RR B2-3CC - 33.2.6 Assembling the rod seal; 33.2.7 Assembling the cylinder; 33.2.8 Assembling the fork carriage

T-code Valid from serial number
403-414, 669-671, 716-718 713962-
Date Order number
2005-06-01 218920-040
33- 4 Service Manual REFLEX RR B/E, RR B/E CC © BT Europe AB
Tilt cylinder – 6660.1
Mast with valve on the fork carriage
33.2.6 Assembling the rod seal
• Press on the rod seal carefully.
33.2.7 Assembling the cylinder
• Insert the rod in the cylinder.
• Tighten with the 8 bolts.
33.2.8 Assembling the fork carriage
• Fit plate (7) and lock in position with the spiral pin (8).
• Fit the tilt cylinder using bolts (10).
• Fit the sliding block (6) and the plate (5) using the bolts (4).
• Lock the sliding block with the bolt/nut (15) so tight that the insert
(14) rotates with difficulty.
• Lift the fork yoke (3) in position using an overhead crane.
• Fit the stop lug (12) using bolts (11).
• Fit the side-shift (2).
• Fit the forks.
1
2
3
4
5
6
78
9
10
11
12
1
3
14
15
https://www.forkliftpdfmanuals.com/