T-code Valid from serial number
403-414, 669-671, 716-718 713962-
Date Order number
2005-06-01 218920-040
4- 4 Service Manual REFLEX RR B,E RR B,E CC © BT Europe AB
Introduction, maintenance – P1
Opening motor compartment
• Ensure that the surface under the jack is clean and free of oil and
grease.
• Ensure that your hands and the jack’s lever are free of oil and
grease.
• Use the lever belonging to the jack. If the lever is too short, it will re-
quire more effort than is necessary. If the lever is too long, there is a
risk of the jack being overloaded.
• Support the truck:
- as close to the raised part of the chassis as possible to reduce the
falling height if the truck tips over.
- so that the truck cannot roll.
• Never block up the jack to lift higher.
• Never work under a lifted truck without well adapted blocking.
WARNING !
Risk of being crushed.
Bad blocking under a truck can collapse
Never work under a truck that is not blocked with pallets and secured
by a lifting device.
4.4 Opening motor compartment
4.4.1 RR B 1-8
To open the motor compartment.
• Loosen the handle beside the driver’s seat and swing the door out-
wards.
To close the motor compartment.
• Close the door and tighten the handle.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...