Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B,E RR B,E CC 35- 3
Main mast –7100
Assembling the mast
35.4 Assembling the mast
• Transport the truck to an assembly area with an overhead crane.
• Cut off the steel band around the support arms.
• Lift off the forks.
• Connect 48 V DC to the truck.
• Extend the reach carriage approximately 200 mm.
• Lift off the load support.
• Extend the reach carriage fully.
• Switch off the current using the ignition and disconnect the 48 V DC.
• Remove the protective plate on the reach carriage.
• Loosen the four M16 bolts and remove the upper part of the stud
bracket (see diagram). Allow any shims under the stud brackets to
remain.
• Using 0 - 2 shims under the stud brackets, the mast incline can be
adjusted laterally. The mast should be 90° ± 6’.
NOTE!
Damage may be caused to the mast studs.
The stud holders are manufactured in pairs.
Do not confuse the right and left stud holders.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...