BT REFLEX RR B2-3CC - 25- Keypad; 25.1 General; 25.2 Display

Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 25- 99
Keypad
General
25- Keypad
25.1 General
This chapter is about the keypad on which you can designate and
change the PIN-codes along with starting the truck.
In the memory of the keypad there are 10 blocks with 10 different driver
PIN-codes which are stored as a standard. The 10 different driver PIN-
codes has different driver profiles. All 100 driver PIN-codes can be
reprogrammed and changed in the driver profiles.
The driver PIN-codes in the keypad or the TLS can be used for log-in
depending how the kaypad is programmed.
25.2 Display
The picture to the left indicates the front of the keypad and the picture to
the right indicates the back. The table describes the terminalnumber
and function of the contact.
The relay can be charged with maximum 10A resistive.
Connection Function Active (V)
X3:1 Relay in 48
X3:2 Battery + 48
X3:3 CAN L 0-5
X3:4 CAN H 0-5
X3:5 Coding PIN 1 0
X3:6 Relay out 48
X3:7 Battery - 0
X3:8 Not used
X3:9 Coding PIN 2 0
5
6
1
9
X
3
https://www.forkliftpdfmanuals.com/