T-code Valid from serial number
403-414, 669-671, 716-718 713962-
Date Order number
2005-06-01 218920-040
15- 16 Service Manual REFLEX RR B/E, RR B/E CC © BT Europe AB
Travel brake system – 3100.2
Maintenance
15.4.3 Check the braking force
The braking force must be checked at least every 1000 operating
hours.
• Lift up the truck so that the drive wheel is free of the ground
• Open the motor compartment covers.
Tools
• Torque wrench set to90 Nm and a M12 flange bolt, or a normal bolt
and flat washer
NOTE!
The bolt quality shall be at least 10.9.
• Screw in the M12 bolt in the hole (for the lifting hole) in the motor ax-
le.
• Turn the motor axle using the torque wrench until the brakes re-
lease.
• If the brake releases before the torque wrench trips the braking force
is too low.
• Adjust the brake play to the right value, see adjusting the play.
• Check the braking force again using the torque wrench.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...