T-code Valid from serial number
403-414, 669-671, 716-718 713962-
Date Order number
2005-06-01 218920-040
41- 12 Service Manual REFLEX RR B,E RR B,E CC © BT Europe AB
Positioning equipment – 9390
Automatic driving
41.10.2 Depositing a load
• Press the LOAD button (the LED now comes on).
• State the required height level using buttons 0--9 (e.g. 5=level 5).
The display shows LE05.
• Raise/lower the forks until they are automatically stopped by the
electronics. If the wrong direction is chosen, no “lift/lower move
-
ment” will take place. The electronics expect the correct direction to
be selected.
• When the forks stop and the LEAVE LED comes on, the forks can be
slid out from under the load.
NOTE!
Forks not horizontal.
The load may slide off the forks or catch on the rack.
The forks must always be horizontal, particularly when the load is be-
ing deposited on or collected from the rack.
• Lower the forks until they are automatically stopped by the electron-
ics and the COLLECT LED comes on.
• Withdraw the forks from the rack. When the work cycle has been
completed, the LEDs will go out.
41.10.3 Inspection
• Press the button INFO to check the required “collect/leave level”.
The value will be shown for three seconds on the display.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...