Valid from serial number T-code
713962- 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 8- 1
Cab heating/ventilation – 0630
General
8- Cab heating/ventilation – 0630
8.1 General
8.2 Air conditioning unit
In order to achieve the greatest possible operator comfort the ventila-
tion and heat can be adjusted to suit your requirements.
8.2.1 Ventilation
The fan can be set to three different speeds.
• Turn the control knob (3) to the required position.
8.2.2 Main heater
• Turn the control knob (2) to 1 to start the heater.
8.2.3 Auxiliary heater
Extra heat may be required when starting a cold truck and when driving
between cold and warm areas.
• Press the button (1) and the heater will give off heat under approx. 7
minutes, after which the heater will be turned off. Press once again if
you wish to restart the heater. The LED on the pushbutton/time relay
is lit when the extra heater is connected.
The time can be adjusted on the time relay inside the heater.
• The interval is adjusted using switch 5.
• The time is adjusted using knob 6.
The higher the fan speed, the greater the amount of hot air
provided in the cab.
8.2.4 Temperature
The temperature can be set from approximately 5 to 30 degrees, using
the thermostat (4).
• Set desired temperature in the cabin using the thermostat (4).
P
P
4
1
2
1
2
4
6
8
10
1m
5
6
LED
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...