BT REFLEX RR B2-3CC - 15.6.1 Adjusting the play

T-code Valid from serial number
403-414, 669-671, 716-718 713962-
Date Order number
2005-06-01 218920-040
15- 20 Service Manual REFLEX RR B/E, RR B/E CC © BT Europe AB
Travel brake system – 3100.2
Maintenance
15.6.1 Adjusting the play
• Dismantle the support arm wheel from the truck and remove the
brake.
• Connect the brake to 48 V D.C.
• Check the play, measurement A, with the brake applied.
NOTE!
Check the play at the same time in two positions at 180 degree spac-
ing.
• Maximum permitted play = 2.25 mm
• Nominal play of newly adjusted brakes shall be 1.0-1.25 mm.
• Before adjusting, dismantle the aluminium end plate.
• Remove the shim washers, when adjusting due to wear, or add shim
washers when fitting new discs.
Each shim washer is 0.127 mm thick.
• Fit the aluminium end plate, connect to 48 V D.C. and check the
play.
• When the play lies within the nominal permitted value, fit the brake in
the wheel and the wheel on the truck.
https://www.forkliftpdfmanuals.com/