Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 24- 65
Electronic card – 5710
Warning codes with registration
Accelerator R1
1. Check that R1 is located in its bracket.
Check that there is no play or oxidisation on the connector
pins on terminal X19. The voltage on input 501 should be 3,7 +/
- 0.2 VDC when R1 is correctly mechanically adjusted.
2. If the correct voltage is on input 501 and the fault remains, re-
place the A5 electronic card.
Code 94
Description Potentiometer R1 for accelerator pedal gives incor-
rect voltage (<0.4 or >4.6 V).
Error mode General error
Error cause 1. Faulty potentiometer/wiring
2. Defective electronic card A5
Comments
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...