Buell 2007 LIGHTNING Service Manual

3-74 2007 Buell Lightning: Engine
HOME
INSTALLATION
1. Install oil line fittings with o-ring into swingarm and
tighten to 108-156 in-lbs (12-17.6 Nm).
2. Push the correct flanged oil line into the correct fitting in
the swingarm until each one clicks in place under the
spring clip.
3. Lightly tug on oil line to verify that it is securely locked to
fitting and the spring clip is seated in the oil line fitting
groove.
4. Check oil level and add oil if required.
5. After running engine,
a. Inspect oil fittings for oil leaks.
b. Check oil level and add oil if required.
Figure 3-109. Flanged Oil Line
12021

Buell 2007 LIGHTNING Specifications

General

Year	2007
Manufacturer	Buell
Model	Lightning
Category	Motorcycle
Displacement	1203 cc
Bore x Stroke	88.9 mm x 96.8 mm
Compression Ratio	10.0:1
Fuel System	Electronic fuel injection
Transmission	5-speed
Final Drive	Belt
Rear Suspension	Showa shock absorber
Rear Brakes	Single disc, 1-piston caliper
Engine Type	V-Twin
Ignition	Digital
Front Suspension	Showa inverted fork
Front Brakes	Single disc, 6-piston caliper
Front Tire	120/70 ZR17
Rear Tire	180/55 ZR17
Wheelbase	52.0 inches
Seat Height	30.1 inches
Dry Weight	395 lbs
Fuel Capacity	14.5 liters