2-2 2007 Buell Lightning: Chassis
HOME
TORQUE VALUES
ITEM TORQUE NOTES
Axle (front) 39-41 ft-lbs 53-56 Nm ANTI-SEIZE, Left handed thread, page 2-16
Axle (rear)
Follow special instructions, ANTI-SEIZE, page 2-
19
Axle pinch fastener, rear 40-45 ft-lbs 54-61 Nm page 2-19
Axle pinch fasteners, front 20-22 ft-lbs 27-30 Nm page 2-16
Battery tray fastener 48-72
in-lbs
5.4-8 Nm page 2-96
Battery tray fasteners 48-72
in-lbs
5.4-8.1 Nm XB12Ss Models, LOCTITE 271, page 2-99
Brake hand lever housing fas-
teners
80-90
in-lbs
9-10 Nm page 2-30
Brake lamp switch fastener,
front
7-10
in-lbs
0.8-1.0 Nm page 2-30
Brake light switch/master cyl-
inder banjo bolt, rear
16-20 ft-lbs 22-27 Nm page 2-41
Brake line p-clamp fastener,
front
36-60
in-lbs
4-7 Nm page 2-32
Brake line P-clamp on inside
of lighting module
36-60
in-lbs
4-7 Nm page 2-32
Brake pedal fastener 22-24 ft-lbs 30-33 Nm LOCTITE 271, page 2-26
Brake pin hanger set, front 11-14 ft-lbs 15-19 Nm page 2-34
Brake pin hanger set, rear 11-14 ft-lbs 15-19 Nm page 2-43
Brake pin plug, rear 24
in-lbs
2.7 Nm page 2-43
Caliper banjo bolt, front 16-20 ft-lbs 22-27 Nm metric, page 2-32
Caliper banjo bolt, rear 16-20 ft-lbs 22-27 Nm page 2-41
Caliper bleeder valves 36-60
in-lbs
4-7 Nm metric, page 2-27
Caliper carrier, rear 24-26 ft-lbs 32-35 Nm page 2-20
Caliper fasteners, front 15-19 ft-lbs 20-26 Nm page 2-34
Caliper mounting fasteners,
front
35-37 ft-lbs 47-50 Nm LOCTITE 271 (red), page 2-34
Caliper mounting large fas-
tener, rear
18-21 ft-lbs 24-28 Nm page 2-44
Caliper mounting small fas-
tener, rear
14-18 ft-lbs 19-24 Nm page 2-44
Center tail section to left and
right tail sections
102-114
in-lbs
11.5-12.8 Nm LOCTITE 271 (red), page 2-98
Chin fairing fasteners 36-48
in-lbs
4-5 Nm LOCTITE 271 (red), page 2-91
Clutch cable fitting to primary 36-108
in-lbs
4-12 Nm page 2-71
Clutch cable wire form 84-92
in-lbs
9.5-10.4 Nm page 2-62
Clutch inspection cover fas-
teners
84-108
in-lbs
9.5-12.2 Nm Tighten in a crosswise pattern, page 2-72
Deflector fasteners 24-36
in-lbs
2.7-4 Nm page 2-68
Deflector pivot shaft risers 43-49
in-lbs
4.8-5.5 Nm page 2-68
To Next Page
Loading...
