Name: Buell 2007 LIGHTNING
Brand: Buell
Rating: 4 (1 reviews)

To Next Page

To Previous Page

7-10 2007 Buell Lightning: Electrical

HOME

SPARK PLUG CABLES 7.4

GENERAL

Resistor-type high-tension spark plug cables have a carbon-

impregnated fabric core, instead of solid wire, for radio noise

suppression and improved reliability of electronic compo-

nents. Use the exact replacement cable for best results.

REMOVAL

1WARNING1WARNING

Never disconnect a spark plug cable with the engine run-

ning. If you disconnect a spark plug cable with the

engine running, you may receive a potentially fatal elec-

tric shock from the ignition system which could result in

death or serious injury.

NOTE

When disconnecting each spark plug cable from its spark

plug terminal, always grasp and pull on the rubber boot at the

end of the cable assembly (as close as possible to the spark

plug terminal). Do not pull on the cable portion itself. Pulling

on the cable will damage the cable’s carbon core.

1. Remove air cleaner assembly. See 4.44 AIR CLEANER

ASSEMBLY.

2. Remove air scoop left side.

3. See Figure 7-8. Disconnect spark plug cables from igni-

tion coil and spark plug terminals. Inspect cables for

damage.

Figure 7-8. Spark Plug Cable Location

1. Front spark plug cable

2. Rear spark plug cable

8843

Questions and Answers:

Need help?

Do you have a question about the Buell 2007 LIGHTNING and is the answer not in the manual?

Buell 2007 LIGHTNING Specifications

General