Name: Buell 2007 LIGHTNING
Brand: Buell
Rating: 4 (1 reviews)

To Next Page

To Previous Page

2007 Buell Lightning: Maintenance 1-45

HOME

10. Cycle the actuator to verify cable and valve operation:

a. Hold the throttle wide open.

b. Turn the engine cut-off switch to RUN.

c. Turn the ignition/light key switch ON.

d. Watch the actuator cycle close/open/close.

CAUTION

DO NOT start vehicle in this mode.

NOTE

In this mode the exhaust valve in the interactive mufﬂer

should cycle from the closed position to the wide open posi-

tion and back to the closed. When the exhaust valve moves to

the open position, you should see the mark on the cable core

made previously. This ensures the system is working prop-

erly. If you do not see the mark, verify previous cable adjust-

ment.

11. See Figure 1-50. Verify that the interactive exhaust cable

(1) is routed behind the frame lug (2) before installing air

intake cover.

CAUTION

If cable is routed in front of the frame lug it will cause the

mufﬂer valve to stay open not allowing it to work prop-

erly.

12. Install air intake cover. See 2.38 INTAKE COVER

ASSEMBLY.

Figure 1-50. Correct Cable Routing Behind Frame Lug

10514a

1. Interactive exhaust cable

2. Frame lug

Questions and Answers:

Need help?

Do you have a question about the Buell 2007 LIGHTNING and is the answer not in the manual?

Buell 2007 LIGHTNING Specifications

General