7-2 2007 Buell Lightning: Electrical
HOME
TORQUE VALUES
Instruments
Turn signal indicator 1 1.12 0.08 Y0163.02A8
Check engine 1 1.12 0.08 Y0163.02A8
High beam 1 0.7 0.05 Y0162.02A8
Oil indicator 1 1.12 0.08 Y0163.02A8
Neutral 1 1.12 0.08 Y0163.02A8
Backlight
2 1.12 0.08 Y0163.02A8
1 0.7 0.05 Y0162.02A8
Low fuel Replace instrument cluster if low fuel warning lamp fails.
Table 7-7. Bulb Chart
BULB CHART
BULBS
REQUIRED
WATTS AMPS
PART
NUMBER
ITEM TORQUE NOTES
Actuator ground wire 48-72
in-lbs
5.4-8.1 Nm page 7-76
Battery (+) to starter fastener 60-85
in-lbs
7-10 Nm page 7-34
Battery terminal fasteners 72-96
in-lbs
8-11 Nm page 7-74
Clutch switch fasteners 7-10
in-lbs
0.8-1.12 Nm page 7-16
Exhaust actuator 36-40
in-lbs
4.1-4.5 Nm page 7-22
Handlebar control housing
screws (left side)
25-33
in-lbs
3-4 Nm page 7-54
Handlebar control housing
screws (right side)
25-33
in-lbs
3-4 Nm Longer screw on bottom, page 7-53
Horn fastener 72-96
in-lbs
8-11 Nm page 7-63
Ignition switch body fastener 12-36
in-lbs
1.4-4.0 Nm page 7-8
Ignition switch fastener 18-20 ft-lbs 24.4-27.1 Nm LOCTITE 271 (red), page 7-9
Instrument module fastener 12-36
in-lbs
1.4-4.0 Nm page 7-57
Main battery ground and the
actuator ground cable to frame
48-72
in-lbs
5.4-8.1 Nm page 7-34
Neutral indicator switch 60-84
in-lbs
6.7-9.4 Nm LOCTITE 243 (blue), page 7-65
Retainter plate fasteners 56
in-lbs
6.3 Nm Always use with new fasteners, page 7-31
Rotor mounting fasteners 120-140
in-lbs
13.5-15.8 Nm page 7-31
Spark plugs 11-18 ft-lbs 15-24 Nm page 7-1
Stator TORX mounting screws 30-40
in-lbs
3-4 Nm
T-27 TORX with retaining compound, replace with
new after each removal, page 7-31
Tail lamp lens and tail light 6-7
in-lbs
0.7-0.8 Nm page 7-46
Turn signal fastener (rear) 25-28
in-lbs
2.8-3.2 Nm page 7-50
Turn signal fasteners (front) 25-28
in-lbs
2.8-3.2 Nm page 7-50
Turn signal flasher fastener 12-36
in-lbs
1.3-4 Nm page 7-51
Voltage regulator mounting
screws
60-72
in-lb
s 6.7-8.1 Nm Use new fasteners, page 7-32
To Next Page
Loading...
Need help?
General
