Buell P3 - Page 203

3-20 2007 Buell P3: Engine
HOME
18. Install clutch cable at hand lever location. See 1.9
CLUTCH.
19. Install drive belt. See 1.11 DRIVE BELT AND REAR
SPROCKET.
20. Install front sprocket cover. See 2.22 SPROCKET
COVER.
21. See Figure 3-32. Install master cylinder onto footpeg
bracket. See 2.21 FOOTPEGS AND FOOTPEG SUP-
PORT BRACKETS.
a. Apply several drops of LOCTITE 243 (blue) to last
few threads.
b. Tighten to 48-72 in-lbs (5-8 Nm).
22. See Figure 3-33. Install right side rider footpeg bracket
assembly. See 2.21 FOOTPEGS AND FOOTPEG SUP-
PORT BRACKETS.
Figure 3-32. Rear Master Cylinder and
Brake Line Assembly
1. Screw
2. Brake fluid reservoir
3. Screw
4. Brake line bracket
5. Screw
6. Brake line
7. Master cylinder
8. Spacer
1
3
6
7
8
54
a0017x3x
2
Figure 3-33. Footpeg Bracket Assembly
1. Frame
2. Locknut
3. Washer
4. Spacer
5. Footrest support bracket
6. Clevis pin
7. Footpeg
8. Cotter pin
9. Index plate
10. Spacer
a0016x3x
1
2
3
4
5
6
7
10
9
8