Table 22-1: CR300 series terminal commands
Command Description Use
A
Operating system copyright
Lists copyright notice and version of operating
system.
C
Modify constant table
Edit constants defined with ConstTable /
EndConstTable. Only active when ConstTable /
EndConstTable in the active program.
D
MTdbg() task monitor Campbell Scientific engineering tool
E
Compile errors
Lists compile errors for the current program
download attempt.
F
Settings names Lists settings
H
Terminal emulator menu Lists main menu.
I
Calibration data
Lists gains and offsets resulting from internal
calibration of analog measurement circuitry.
J
Download file dump Sends text of current program including comments.
L
Peripheral bus read Campbell Scientific engineering tool
M
Memory check Lists memory-test results.
N
File system information Lists files in CR300 series memory.
O
Data table sizes Lists technical data concerning data-table sizes.
P
Serial talk through
Issue commands from keyboard that are passed
through the logger serial port to the connected
device. Similar in concept to SDI12 Talk Through. No
timeout when connected via PakBus.
REBOOT
Program recompile
Typing “REBOOT” rapidly will recompile the CR300
series program immediately after the last letter, "T",
is entered. Table memory is retained. NOTE: When
typing REBOOT, characters are not echoed (printed
on terminal screen).
SDI12
SDI12 talk through
Issue commands from keyboard that are passed
through the CR300 series SDI-12 port to the
connected device. Similar in concept to Serial Talk
Through. See also SDI-12 transparent mode(p. 181)
22. Tips and troubleshooting180
To Next Page
Loading...
