Campbell CR310 - Installation; Modules Using Konect Pakbus Router (Private Dynamic IP); Configure Data Logger

12.2 Installation
12.2.1 Modules using Konect PakBus Router (private dynamic IP) 41
12.2.2 Modules using a public static IP 46
12.2.1 Modules using Konect PakBus Router (private
dynamic IP)
12.2.1.1 Configure data logger 41
12.2.1.2 Set up LoggerNet 43
12.2.1.3 Test the connection 45
12.2.1.1 Configure data logger
1. Connect the cellular antenna, if it is not already connected. When using a MIMO antenna
with multiple cellular connections, connect the primary cable to Cellular and the secondary
to Diversity. If the cables are not marked in this way, they can be connected to either
antenna port.
2. Connect to your data logger by using Device Configuration Utility.
12. Cellular communications option41