memory available for program and data storage. Changing this setting will force the data logger
to recompile its program so that it can reallocate memory
23.3.55 TLSPassword
This setting specifies the password that will be used to decrypt the TLS Private Key setting.
l
String data type
23.3.56 TLSStatus
Reports the current status of the data logger TLS network stack.
l
String data type
l
Read only
23.3.57 UTCOffset
Specifies the offset, in seconds, of the data logger's clock from Coordinated Universal Time (UTC,
or GMT). For example, if the clock is set to Mountain Standard Time in the U.S. (-7 Hours offset
from UTC) then this setting should be -25200 (-7*3600). This setting is used by the NTPServer
setting as well as EmailSend() and HTTP(), which require Universal Time in their headers. This
setting will also be adjusted by the Daylight Savings functions if they adjust the clock.
If a value of -1 is supplied for this setting, no UTC offset will be applied.
23.3.58 Verify
This setting specifies the interval, in units of seconds, that will be reported as the link verification
interval in the PakBus hello transaction messages. It will indirectly govern the rate at which the
data logger will attempt to start a hello transaction with a neighbor if no other communications
have taken place within the interval.
23.3.59 Cellular settings
Access cellular settings, using Device Configuration Utility. Clicking on a setting in Device
Configuration Utility also provides information about that setting. These settings are available for
data loggers with integrated CELL modules.
23. Information tables and settings (advanced)222
To Next Page
Loading...
Need help?
General
