Campbell CR310 - Connect Your Computer to the Data Logger over Wi-Fi; Set up Loggernet or PC400 W

11.1.4 Connect your computer to the data logger over
Wi-Fi
1. Open the Wi-Fi network settings on your computer.
2. Select the Wi-Fi-network hosted by the data logger. The default name is CR300 followed by
the serial number of the data logger. In the previous image, the Wi-Fi network is CRxxx.
3. If you set a password, select the Connect Using a Security Key option (instead of a PIN) and
type the password you chose.
4. Connect to this network.
11.1.5 Set up LoggerNet or PC400W
1. Using data logger support software, launch the EZSetup Wizard.
NOTE:
New software installations automatically open the EZSetup Wizard the first time they
run.
l
LoggerNet users, click Setup , select the View menu and ensure you are in the EZ
(Simplified) view, then click Add Datalogger .
l
PC400 users, click Add Datalogger .
11. Wi-Fi communications option32