23.2.29 RevBoard
Electronics board revision in the form xxx.yyy, where xxx = hardware revision number; yyy = clock
chip software revision. Stored in flash memory. Updated at startup.
l
String data type
23.2.30 RunSignature
Signature of the running binary (compiled) program. Value is independent of comments or non-
functional changes. Often changes with operating-system changes. Updates after compiling and
before running the program.
23.2.31 SerialNumber
CR300 series serial number assigned by the factory when the data logger was calibrated. Stored
in flash memory. Updated at startup.
23.2.32 SerialFlashErrors
Reports on the serial flash health and provides the number of errors detected in serial flash. 0 =
No errors detected. For detailed information on serial flash, see Flash memory(p. 89).
23.2.33 SkippedScan
Number of skipped program scans (see Checking station status(p. 169) for more information)
that have occurred while running the CRBasic program. Does not include scans intentionally
skipped as may occur with the use of ExitScan and Do / Loop instructions. Updated when they
occur. Enter 0 to reset.
23.2.34 SlowProcTime
Processing time (μs) of the last Slow Sequence scan. Time is measured from the end of the
EndScan instruction (after the measurement event is set) to the beginning of the EndScan
(before the wait for the measurement event begins) for the subsequent scan. Calculated on-the-
fly. Updated at the conclusion of scan processing, prior to waiting for the next scan.
23. Information tables and settings (advanced)209
To Next Page
Loading...
Need help?
General
