Campbell CR310 User Manual

Where to find:
l
Settings Editor tab in Device Configuration Utility: Cellular > PDPCell Authentication
Password
23.3.59.8 CellPDPUserName
Specifies the username used for PDP authentication. Often there is no username, and this field
can be left blank. If a Username is required, it will be provided by your cellular provider with the
APN.
l
String data type
Where to find:
l
Settings Editor tab in Device Configuration Utility: Cellular > PDPCell Authentication
Username
23.3.59.9 CellPwrDuration
Specifies the interval, in minutes, over which the data logger will power its cellular interface. This
can be done to save on battery life or cellular charges. This is adjusted using three components:
l
Start (Power-On) Time: Specifies the time of day in terms of hours and minutes in which the
data logger will first enable the cellular interface. If left at the default value of Always On,
the data logger will power the cellular interface at all times.
l
On Duration: Specifies the interval, in minutes, to power the data logger cellular interface
for the first time of any day as well as for any repeat cycles (if applicable).
l
Repeat Cycle: Specifies the interval after the first time that the data logger powers on its
cellular interface, that the data logger will power its cellular interface at subsequent times
throughout the day.
For example, setting a Start Time of 08:00, with an On Duration of 15 minutes, and a Repeat Cycle
of Every Hour, will result in the cellular module being powered on at 8:00AM for 15 minutes every
hour until midnight.
l
Long data type
Where to find:
l
Settings Editor tab in Device Configuration Utility: Cellular > On duration
23. Information tables and settings (advanced)225

Campbell CR310 Specifications

General

Brand	Campbell
Model	CR310
Category	Data Loggers
Language	English