throughput rate
Rate that a measurement can be taken, scaled to engineering units, and the stored in a final-
memory data table. The data logger has the ability to scan sensors at a rate exceeding the
throughput rate. The primary factor determining throughput rate is the processing
programmed into the CRBasic program. In sequential-mode operation, all processing called
for by an instruction must be completed before moving on to the next instruction.
time domain
Time domain describes data graphed on an X-Y plot with time on the X axis. Time series data
is in the time domain.
TLS
Transport Layer Security. An Internet communications security protocol.
TOA5
Also called ASCII, Long Header. Data stored in a comma separated format. Header
information for each column is included, along with field names and units of measure if they
are available. Table output ascii version 5. See the LoggerNet manual appendix for details on
differnet file formats.
TOACI1
Also called ASCII, Short Header. Data stored in a comma separated format. Header
information for each of the columns is included. Table output ASCII version 1. See the
LoggerNet manual appendix for details on differnet file formats.
TOB1
Binary. Data stored in a binary format. Though this format saves disk storage space, it must
be converted before it is usable in other programs. Table output binary version 1. See the
LoggerNet manual appendix for details on differnet file formats.
TOB3
Binary. Data stored to a card in a binary format. Table output binary version 1. See the
LoggerNet manual appendix for details on differnet file formats.
Appendix C. Glossary292
To Next Page
Loading...
