6. Setting up the CR300 series 18
7. Setting up communications with the data logger 19
8. USB or RS-232 communications 21
9. Virtual Ethernet over USB (RNDIS) 24
10. Ethernet communications option 26
10.1 Configuring data logger Ethernet settings 26
10.2 Ethernet LEDs 27
10.3 Setting up Ethernet communications between the data logger and computer 27
11. Wi-Fi communications option 29
11.1 Hosting a Wi-Fi network 29
11.1.1 Configure the data logger to host a Wi-Fi network 30
11.1.2 Connect your phone to the data logger over Wi-Fi 30
11.1.3 Set up LoggerLink 31
11.1.4 Connect your computer to the data logger over Wi-Fi 32
11.1.5 Set up LoggerNet or PC400W 32
11.2 Joining a Wi-Fi network 33
11.2.1 Configure the data logger to join a Wi-Fi network 34
11.2.2 Set up LoggerNet or PC400W 34
11.3 Wi-Fi LED indicator 35
12. Cellular communications option 37
12.1 Pre-installation 38
12.1.1 Establish cellular service 38
12.1.1.1 Selecting a data service 38
12.1.2 Install the SIM card 39
12.1.3 Konect PakBus Router setup 39
12.1.3.1 Get started 39
12.1.3.2 Set up Konect PakBus Router 40
12.2 Installation 41
12.2.1 Modules using Konect PakBus Router (private dynamic IP) 41
12.2.1.1 Configure data logger 41
12.2.1.2 Set up LoggerNet 43
12.2.1.3 Test the connection 45
12.2.2 Modules using a public static IP 46
12.2.2.1 Configure data logger 46
Table of Contents - ii
To Next Page
Loading...
