Handling sheets for paper feed slots
Loading Sheets Manually
When using the tray , load the paper in the T op Paper Feed Slot . (→P .183) However , if you have specied
POP Board , insert the sheet in the Front Paper Feed Slot . (→P .186)
Loading paper in the T op Paper Feed Slot
Note
• Y ou can load only one sheet in the T op Paper Feed Slot . Do not load more than one sheet at a time.
This may cause paper jams.
• Store unused paper in the original package, away from high temperature, humidity , and direct sunlight.
• Paper that is wrinkled or warped may jam. If necessary , straighten the paper and reload it.
• Load the paper straight. Loading paper askew will cause an error .
• Before feeding paper or printing, make sure the sheet is at against the Paper T ray Cover . The sheet
may jam if it curls before feeding or printing and the trailing edge drops toward the front.
• If a roll is loaded, rewind the roll before this procedure. ( → P .146)
1. If you send a print job specifying a paper other than POP Board from a computer beforehand,
the type and size of paper are shown on the Display Screen .
Note
• If you will load paper before sending a print job, press the Feeder Selection button to illuminate the
Paper T ray lamp . A screen is displayed for selection of the paper type. Press ◄ or ► to select the
paper type, and then press the OK button. Next, a screen is displayed for selection of the paper size.
Press ◄ or ► to select the size of paper , and then press the OK button.
• For details on paper types, see the Paper Reference Guide . ( → P .107) By factory default, Plain
Paper is selected.
• Be sure to select the correct paper type. If this setting does not match the loaded paper , it may
cause feed errors and af fect the printing quality .
2. Open the Paper T ray Cover .
Handling Paper 183
To Next Page
Loading...
Need help?
General