Messages regarding printheads
Messages regarding printheads
Online Key / and recalibrate
Band Adj Error / Please Readjust
Cause Corrective Action
The feed amount cannot be adjusted; highly
transparent lm is loaded.
Adjust the feed amount manually .
( → P .619)
Printhd Adj Err / Please Readjust
Cause Corrective Action
The Printhead nozzles are clogged. Follow the steps below to check the nozzles.
1. Print a test pattern to check the nozzles.
( → P .651)
2. Clean the Printhead if the nozzles are clogged.
( → P .652)
The Printhead cannot be aligned; highly transparent
lm is loaded.
W e recommend using a type of paper that you often
use, other than lm, for Printhead adjustment.
( → P .610)
Printhead x / Check Nozzles (x is Left or Right)
Cause Corrective Action
If printing is faint, clean the Printhead.
If “Left Printhead” is displayed, clean the Printhead L
; if “Right Printhead” is displayed, clean the Printhead
R .
( → P .652)
The printhead nozzles may be clogged.
Press the Online button to continue with printing.
However , note that this error may af fect the printing
quality .
T o cancel printing, press the Stop/Eject button.
756 Error Message
To Next Page
Loading...
