Other Messages
Power On / Again
Cause Corrective Action
Fastening tape or the Belt Stopper has not been
removed inside the T op Cover .
Follow the steps below , referring to the Quick Start
Guide as needed.
1. T urn the printer of f.
2. Open the T op Cover and remove the tape or Belt
Stopper .
3. T urn the printer on.
There is a paper jam. Follow these steps.
1. T urn the printer of f.
2. Remove the jammed paper .
( → P .173)
( → P .138)
( → P .179)
3. T urn the printer on.
4. Reload the paper .
( → P .80)
( → P .82)
( → P .86)
T urn of f the printer and wait for three seconds or
more before restoring the power .
There is a problem with the printer .
If the message is still displayed after this, write down
the error code and message, turn of f the printer , and
contact the Canon dealer for assistance.
760 Error Message
To Next Page
Loading...
