Other problems
Paper cannot be cut
Cause Corrective Action
The printed document became caught on a foreign
object by the Output T ray , which lifted the document.
The Cutter passed under the paper .
Remove the foreign object by the Output T ray to
enable the printer to eject the printed document,
keeping it level.
In the printer driver , No or Print Cut Guideline is
specied in Auto Cut .
Specify Y es in Auto Cut in the printer driver .
In MAIN MENU , Eject or Manual is specied in
Cutting Mode .
Specify Automatic in Cutting Mode in MAIN MENU .
Depression on the leading edge is left
Cause Corrective Action
Keeping a roll in the printer for a long time without
printing on it may leave a depression on the leading
edge.
When printing quality is most important, we
recommend setting T rimEdge Reload to On or
Automatic so that the paper edge is automatically
cut before printing.
Roller marks are left across the trailing edge of paper
Cause Corrective Action
Following the instructions, press the ▲ button,
remove the paper , and then press the ▼ button.
A document was removed after printing from the
Front Paper Feed Slot without pressing the ▲ button.
Wipe away any soiling on the rollers. ( → P .670)
( → P .673)
The printer does not go on
Cause Corrective Action
The printer is unplugged. Plug the power cord into the outlet, and then turn on
the printer .
The specied voltage is not supplied. Check the voltage of the outlet and breaker .
For information on the specied voltage, see
“Specications”. (→P .72)
T roubleshooting 725
To Next Page
Loading...
Need help?
General