Messages regarding paper
Cutting Error
Cause Corrective Action
There are sheets left on the Output T ray . Remove the paper .
There is a foreign object by the Output T ray ,
obstructing the Cutter Unit .
Remove the foreign object.
Y ou are not using the printer under the recommended
environmental conditions for the paper .
Use the printer only where the recommended
environmental conditions for the paper are met.
Note that various environmental conditions are
recommended for various types of paper . For details
on the recommended environmental conditions for
paper , see “T ypes of Paper”. (→P .107)
Y ou are using paper that is not compatible with
automatic cutting.
Cut the roll manually .
( → P .130)
The Cutter Unit stops in the middle of cutting. Move the Cutter Unit to the left, and then remove the
roll paper . If the roll cannot be cut using the Cutter
Unit , cut the roll manually .
( → P .130)
In other cases, the Cutter Unit may be damaged. Contact your Canon dealer for assistance.
Roll P Unit / Please Check
Cause Corrective Action
Change the paper source in the printer driver to a
source other than roll, and then try printing again.
The printer has received a print job that species
rolls, but the Roll Feed Unit is not installed.
Install the Roll Feed Unit and resend the print job.
748 Error Message
To Next Page
Loading...
Need help?
General