Printing procedure
Loading and Printing on Rolls
These are the basic steps for loading and printing on rolls.
Follow the steps below to switch to a new roll or a roll of a dif ferent type or width before printing.
Note
• If a sheet is loaded in the T ray , remove it before this procedure. ( → P .146)
• Before printing banners or other large-format documents, spread a clean cloth or paper over the oor .
Long sheets that touch the oor after printing may become dirty .
• If you will wait for the ink to dry after printing and simply eject the document, you can deactivate
automatic cutting and print a cut line instead. ( → P .130)
1. T urn the printer on. (→P .20)
2. Select roll paper (a) as the paper source. (→P .1 14)
82 Basic Printing W orkow
To Next Page
Loading...
Need help?
General