Network Setting
8. Press ◄ or ► to select the number , and then press the OK button.
IP Address
=xxx.0.0.0
Note
• Pressing the ◄ button decreases the number by 1. The minimum value is “0,” after which “255” is
displayed.
• Pressing the ► button increases the number by 1. The maximum value is “255,” after which “0” is
displayed.
• Hold down ◄ or ► to increase or decrease the value continuously .
9. Repeat steps 6-8 to enter the IP address assigned to the printer .
IP Address
=xxx.xxx.xxx.xxx
10. Press the Online button to bring the printer online.
If any of the settings are changed, a message for conrmation is displayed. In this case, press
the OK button.
Note
• If an error message is displayed, check the settings and correct any invalid values.
• T o cancel the setup process, hold down the Stop/Eject button for a second or more.
Important
• Be sure to complete step 10. This will activate the values you have entered.
• Y ou can also specify the subnet mask and default gateway on the Control Panel .
576 Network Setting
To Next Page
Loading...
