Adjusting the Printhead
5. Press ◄ or ► to select Y es , and then press the OK button.
The setting is updated, and an equals sign “=” is displayed at left.
Manual Head Adj
= Y es
A test pattern is printed for printhead adjustment.
6. After Adj.Setting is displayed, press ▼ .
Adj.Setting
D ↓
7. Press ▼ .
D
D-1
8. Examine test pattern D-1 for printhead adjustment. After you determine the pattern with straight
lines, press ◄ or ► to choose the pattern number , and then press the OK button.
D-1
=10 ↓
Note
• If you cannot determine the pattern with straight lines, choose an intermediate value. For example,
choose 1 1 if you cannot decide whether pattern 10 or 12 is better .
9. Repeat steps 7 and 8 to specify the adjustment value for D-2 to D-5 and D-7 to D-1 1 .
10. Press ▲ .
1 1. Press ◄ or ► to select Save Settings , and then press ▼ .
Adj.Setting
Save Settings ↓
12. Press ◄ or ► to select Y es , and then press the OK button.
The setting is updated, and an equals sign “=” is displayed at left.
Save Settings
= Y es
The printer now goes online.
Maintenance 613
To Next Page
Loading...
Need help?
General