Printheads
Replacing the Printhead
Follow the steps below to replace the Printhead . Failure to follow this procedure may cause ink leak from
the Printhead , which may cause stains.
Note
• Prepare a new Ink T ank when ink levels are low .
• Y our hands may become dirty during Printhead replacement. Use the gloves provided with the new
Printhead for replacement.
• Choose On in Auto Print to have the printer automatically adjust the Printhead alignment after
replacement of the Printhead . ( → P .47)
1. If the roll is not ejected because of the cutting method selected, cut it manually and remove it.
( → P .447)
2. Clean inside the T op Cover . ( → P .670)
3. Press the Menu button to display MAIN MENU .
4. Press ◄ or ► to select Maintenance , and then press ▼ .
MAIN MENU
Maintenance ↓
5. Press ◄ or ► to select Replace P .head , and then press ▼ .
Maintenance
Replace P .head ↓
6. Press ◄ or ► to select Printhead , and then press ▼ .
Select Left Printhead to replace the left Printhead or select Right Printhead to replace the
right Printhead .
Replace P .head
Left Printhead ↓
654 Maintenance
To Next Page
Loading...
Need help?
General