Setting Up Dialup Modems
148 Check Point UTM-1 Edge User Guide
5. Complete the fields using the information in Dialup Fields on page 148.
6. Click Apply.
7. To check that that the values you entered are correct, click Test.
The page displays a message indicating whether the test succeeded.
8. Configure a Dialup Internet connection on the Serial port.
See Using Internet Setup on page
113.
Table 29: RS232 Dialup Fields
In this field… Do this…
Modem Type Select the modem type.
You can select one of the predefined modem types or Custom.
If you selected Custom, the Installation String field is enabled. Otherwise,
it is filled in with the correct installation string for the modem type.
Initialization String Type the installation string for the custom modem type.
If you selected a standard modem type, this field is read-only.
Dial Mode Select the dial mode the modem uses.
Port Speed Select the Serial port's speed (in bits per second).
The Serial port's speed must match that of the attached dialup modem.
The default value is 57600.
Answer incoming
PPP calls
Select this option to specify that the modem should answer incoming
PPP calls. This allows accessing the appliance out of band for
maintenance purposes, in case the primary Internet connection fails.
To Next Page
Loading...
